BB10768-301(1)Quick Start GuideThank you for purchasing these FUJIFILM products.This Quick Start Guide provides you with a simple summary of how conne
19Windows186. To exit Exif Viewer, select “Exit” from the “File”menu or click the [Close] button in the mainwindow.✽For more information on using Exif
21Windows20NOTEIf you cannot find USB Mass Storage in the “USB Controller” list, look under“Other devices”.8. Select the “Driver” tab and click the [U
23Macintosh22Pre-installation ChecklistInstallation on a MacintoshHardware and software requirementsTo run this software, you must have the hardware a
25Macintosh243. Check whether File Exchange is active.To use a media that is supported by the camera, the File Exchange utility suppliedwith Mac OS mu
27Macintosh26Installing the Enclosed Applications1. When you load the enclosed CD-ROM into the CD-ROM drive and double-click the CD-ROM icon,the “Exif
29Macintosh28Connecting the Camera and Macintosh and Viewing ImagesUsing the Software on a Macintosh✽Refer to the Owner’s Manual for your camera for i
31Macintosh30Uninstalling the Software on a MacintoshUse this procedure only when the installed software is no longer required orwhen software install
3332 (Mac) Is the USB Driver active?Solution: Select “USB04CB_StorageShim” and “USB04CB_StorageDriver” in theExtensions Manager and restart your Maci
3534Windows-specific ProblemsThe camera is connected to my PC but the driver installation willnot start. Is the camera switched on?Solution: Switch t
37Macintosh-specific ProblemsThis message appeared when I connected the camera to myMacintosh. Is the USB Driver installed?Solution: Install the driv
32IMPORTANTBe sure to read this page before using the Software.Please note that this Guide is written on the assumption that you already have a basicu
MEMO MEMO
Printed in Japan FGS-002110-FGThis brochure uses recycled paper.
5Windows4IntroductionSoftware OverviewThis section briefly describes the software programs provided on the enclosedCD-ROM.USB Mass Storage DriverThe U
7Windows6Installing the SoftwareThis section describes the setup procedure for using the USB Driver on Windows.1. Switch on your PC and start up Windo
9Windows89. Select the\USBDRV\WIN98 folderon the CD-ROM drive,click the [OK] button,and then click [Next >].in the “Add NewHardware Wizard”dialog b
11Windows6. The “Found NewHardware Wizard”window opens. Clickthe [Next >] button.If this Wizard doesn’t appear, update theUSB driver (See P.20).7.
13Windows12Installing the Enclosed Applications1. Quit any other applications that are running.Quit all other active applications until noapplications
15Windows146. When the DP Editor setup ends, the QuickTimeSetup program starts up.Proceed with the installation asdirected by the on-screen instructio
17Windows16Connecting the Camera and PC and Viewing ImagesUsing the Software on Windows✽Refer to the Owner’s Manual for your camera for information on
Kommentare zu diesen Handbüchern